Arc Raiders Trap Guide | Where U4GM Adds Insight

[Glico]

The Jump Mine question in Arc Raiders is really about two things: which item the Trial means, and whether a mine still matters after its owner extracts. If you are sorting gear, comparing ARC Raiders BluePrints, or planning a Trial run, the useful answer is simple: the "Jump Mine" objective refers to the Explosive Mine. Its behavior can look confusing, especially when a placed device still rises and detonates after its owner has left.

Jump Mine Means the Explosive Mine

Players looking for a separate item named Jump Mine can lose time before the raid even starts. The current Trial wording uses "Jump Mine," but the inventory item you need is the Explosive Mine.

The nickname comes from its activation animation. When a target enters its range, the mine rises before detonating. That visual movement explains the alternate name, but it does not indicate a different piece of equipment.

For the ARC damage Trial, progress comes from damage caused to ARC targets with the Explosive Mine. The listed milestones are 1,000 points for one star, 2,000 for two, and 3,000 for three. Check your loadout before deploying rather than assuming another trap type will count.

What Happens When the Owner Extracts?

Recent community footage suggests that some traps can remain visible after their owner extracts, trigger normally, and still fail to damage or disrupt another Raider. The sound, movement, and detonation may all occur, making the result look far more dangerous than it is.

That does not prove every deployed device follows the same rule. Different trap types, locations, and combat interactions may behave differently, and there is no clear official explanation covering every case.

The most sensible reading is that a placed mine may remain visually present while losing its active combat link once its owner is gone. In practical terms, the model can stay in the world even if its harmful effect no longer applies. Treat that as a reported behavior, not a guaranteed rule you can safely test during a valuable run.

How to Approach Mines You Find

A harmless detonation clip should not convince you to walk through every mine in Arc Raiders. You usually have no way to know whether the owner extracted, rotated elsewhere, or is holding an angle nearby.

◆ Assume a newly spotted mine can still hurt you.

◆ Check doorways, ladders, zip-line exits, and tight passages for follow-up pressure.

◆ Listen for movement after a mine activates, since the blast can be used to force hesitation.

◆ Keep another route open when possible, because one visible device may support a wider setup.

The key distinction is between activation and effect. A mine can react to your presence without producing damage, but you should never rely on that outcome when extraction and carried loot are on the line.

Use Explosive Mines While You Can Capitalize

An Explosive Mine is strongest when it supports a plan instead of replacing one. Place it where ARC units are likely to gather, then stay close enough to benefit from the opening. A mine can delay movement, reveal an approach, pressure a route, or damage a compact group.

For Trial efficiency, target density matters more than chasing one durable machine. A single blast hitting several smaller ARC units can produce better progress than a clean hit on one large target. Controlled rooms, narrow entrances, and limited exits give you better odds of keeping targets within the effective area.

Do not place the mine too early. The first unit entering range can trigger it before the rest arrive, wasting the attempt. Gather the targets, reduce their space to spread out, then deploy when the group is close enough. Stay alive long enough to confirm the damage before heading out.

For Arc Raiders players, the practical choice is to use the Explosive Mine during an active encounter and regard leftover traps with caution. If you need supplies to prepare another Trial attempt, you can buy ARC Raiders Items and focus on placement, timing, and concentrated ARC targets rather than expecting a mine to finish work after extraction.